文章摘要
刘雄.基于DEFORM的导电切削GCr15主切削力研究[J].润滑与密封,2018,43(3):88-91
基于DEFORM的导电切削GCr15主切削力研究
Research on Main Cutting Force of Electric Heating Machining GCr15 Steel Based on DEFORM 3D
  
DOI:10.3969/j.issn.0254-0150.2018.03.014
中文关键词: GCr15钢  DEFORM 3D  导电加热切削  切削力  正交实验
英文关键词: GCr15 steel  DEFORM 3D  electric heating machining  cutting force  orthogonal experiment
基金项目:教育部“春晖计划”合作科研项目(Z2016132);国家人社部留学回国人员科技活动择优资助项目(2013年);西华大学省部级学科平台制造与自动化重点实验室(重点研究基地)开放课题(szjj2015-081); 流体及动力机械教育部重点实验室研究基金(西华大学 JYBFX-YQ-1, szjj2016-010).
作者单位E-mail
刘雄 西华大学机械工程学院西华大学流体及动力机械教育部重点实验室 liuxiong199010@163.com 
摘要点击次数: 1308
全文下载次数: 0
中文摘要:
      为了降低切削高强度高硬度难加工材料时的切削力,减少加工区域内的温升和刀具磨损,通过YT726刀具导电加热切削GCr15钢仿真实验,采用DEFORM 3D有限元计算和回归分析的方法,研究背吃刀量、切削速度、进给量和加热电流之间的相互关系,提出YT726切削GCr15钢的主切削力的计算公式。试验结果表明:主切削力与切削速度、进给量、背吃刀量呈正相关性,与切削温度呈负相关性,当加热电流大于一定量值后主切削力与加热电流也成负相关,即随着加热电流的增加主切削力降低。
英文摘要:
      In order to reduce the cutting force of high strength,high hardness material cutting,and reduce temperature and tool wear in machining area,the simulation experiments of YT726 tool cutting GCr15 steel were carried out with electric conducting heating.By using finite element calculation and regression analysis method based on DEFROM 3D,the relationship among cutting depth,cutting speed,feed rate and heating current were studied,the calculation formula of the main cutting force of YT726 tool cutting GCr15 steel was put forward.The results show that the main cutting force is positively correlated with cutting speed,feed rate and cutting depth,and negatively correlated with cutting temperature.When the heating current is greater than a certain value,the main cutting force is also negatively correlated with the heating current,and with the increasing of heating current,the main cutting force is decreased.
查看全文   查看/发表评论  下载PDF阅读器
关闭

分享按钮